Install XGS2 Chassis
The installation procedure for both XGS2-HS and XGS2-SD chassis are the same. The following
sections describe the procedure.
1.
Insert the controller module in the
lower slot in front of the chassis.
Ensure that the module is fully
seated.
Ensure that the thumbscrews are
screwed in properly.
2.
Take the Sync module and insert
it in its slot on the back of the
chassis.
Chapter 2 XGS2 Chassis Physical Setup
– 10 –
Summary of Contents for Ixia IxOS XGS2 Series
