NOTE: The installation of your equipment and rack kit in a rack cabinet has not been approved
by
any safety agencies. It is your responsibility to ensure that the final combination of equipment and
rack complies with all applicable safety standards and local electric code requirements. Ixia disclaims
all liability and warranties in connection with such combinations. Rack kits are intended to be installed
in a rack by trained service technicians.
When setting up the equipment for use:
l
Place the equipment on a hard, level surface.
l
Leave plenty of clearance on all vented sides of the equipment to permit the airflow required for
proper ventilation. Restricting airflow can damage the equipment.
l
Ensure that nothing rests on your equipment’s cables and that the cables are not located where
they can be stepped on or tripped over
l
Keep your equipment away from radiators and heat sources. Keep your equipment away from
extremely hot or cold temperatures to ensure that it is used within the specified operating range.
l
Do not stack equipment or place equipment so close together that it is subject to re-circulated or
preheated air
When operating your equipment:
CAUTION: Do not operate your equipment with the cover removed.
l
Use this product only with approved / certified equipment. Operate this product only with
approved /certified redundant power supplies.
l
Operate the equipment only from the type of external power source indicated on the electrical
ratings label. If you are not sure of the type of power source required, consult your service
provider or local power company.
l
Use only approved power cable(s). If you have not been provided with a power cable for the
equipment or for any AC-powered option intended for the equipment, purchase a power cable that
is approved for use in your country. The power cable must be rated for the equipment and for the
voltage and current marked on the equipment’s electrical ratings label. The voltage and current
rating of the cable should be greater than the ratings marked on the equipment.
l
Do not modify power cables or plugs. Consult a licensed electrician or your power company for
site modifications. Always follow your local/national wiring rules.
Appendix A Safety Instructions
– B –
Summary of Contents for Ixia IxOS XGS2 Series
