30
M9383A Startup Guide
Startup Guide
Assemble the M9383A
3.
On the M9021A module, set both S301 switches to the “Host” (right-hand)
position and set the S201 rocker switch to the left-hand position. Refer to
the following figure for M9021A switch locations and positions.
4.
Install the M9021A Cable Interface module into the chassis:
a.
While holding the module by the injector/ejector handle and
making sure the injector/ejector handle is pushed down in the
unlatched (downward) position, slide the M9021A module into
chassis, using the slot guides (top and bottom).
b.
Slide the module into position, when you begin to feel resistance,
pull up on the injector/ejector handle to fully inject the module into
the chassis backplane connectors.
c.
Tighten the module retaining screws (top and bottom) and torque
them to 5 in-lb (0.57 N-m).
5.
Connect the M9021A to your desktop PC. If you are using a desktop PC as
a controller, connect to the M9021A using the following components:
The above procedure addresses using the M9021A as a cabled PCIe interface
between the M9018B/M9019A chassis and an external host computer.
However, if you intend to use an M9021A module to control a subordinate
downstream chassis:
