MX0100A InfiniiMax Micro Probe Head
6
InfiniiMax RC Probe Amplifier and Probe Heads User’s Guide
57
Soldering an MX0100A Probe Head to DUT
To solder the probe tip lead wires to DUT
1
Trim the length of the MX0100A probe head lead wires to match your DUT’s
geometry (see
). You may use the cutting tweezers (Keysight part
number 8710-2838) included in the Soldering toolkit.
2
Apply flux to both DUT and MX0100A probe tip lead wires. Always use plenty of
flux, even if your solder already contains flux. This cleans the solder joint and
allows for easier flowing solder and quicker dwell times.
3
Add solder to existing test points on DUT, if necessary. Heat momentarily and
do not dwell any longer than necessary!
NOTE
You can spread the probe head’s lead wires within the range of 0mm to 7mm
span without causing any significant variation in its available bandwidth.
NOTE
The tools included in the MX0102A soldering toolkit can be of great use
while soldering the MX0100A probe head to DUT (see
). You may
purchase this toolkit separately.
