©2019 Copyright Kappers Fabricating, Inc. All rights reserved
2
5. This mount comes with a wide fairlead opening. If
you have a standard or 2 hole winch you will need to
install the wide to standard adapter plate (3) Figure 5 .
If you have a wide winch you will not need the standard
adapter plate (3). Mount roller/hawse fairlead to bumper
according to your winch manual. Figure 1&5
6. Loosely bolt support bracket (2) and winch mount (1)
together with four M8 bolts (6.4). Figure 1, 5 & 7
7. Install your winch upside down to the winch mount (1)
using the hardware provided with your winch. Figure
6,7 shows a standard winch bolt pattern 3”x 4 7/8”. Use
the outside set of holes for a wide winch 3”x 6.60” and
the center set of holes for a 2 hole winch. Motor will be
on the drivers side with clutch on the passenger side.
8. Install winch and winch mount assembly (1) & (2) to
bolt plate (4) installed in step 4 using the two included
M10 Hex Bolts (6.3) Figure 8
“Figure 6” Winch installation
9. Reinstall tow hook hardware (E) removed from step 3
Figure 9
10. Tighten all hardware
1
2
“Figure 5” Fairlead installation
3
6.4
E
“Figure 9” Tow Hook
Hardware Reinstall
6.3
“Figure 8” Winch Mount
Assembly
Wide
2 Hole
Motor
Clutch
1
2
6.4
“Figure 7” Winch bolts
(Shown with standard winch)
Motor
Clutch
