12
ASP-35
Maintenance
The owner/operator is responsible for all periodic
maintenance.
Improper maintenance will void your warranty.
Never operate a damaged or defective winch.
NOTE
For service or parts assistance, contact our help
line at 1-877-346-2050.
WARNING
WARNING
Complete all scheduled maintenance in a timely
manner. Correct any issue before operating the
winch.
Lubrication
All moving parts within the Electric Winch have
been lubricated using high temperature lithium
grease at the factory. No internal lubrication is
required under normal conditions. If the winch is
subjected to extreme conditions lubrication may be
required using a high temperature lithium grease.
Cable Assembly Replacement
It is recommended that any modifications be
performed by a manufacturer’s authorized repair
facility, and that only manufacturer-supplied parts
be used.
1. Rotate the clutch cap to the “Release”
position.
2. Extend Cable Assembly to its full length. Note
how the existing cable is connected to the
inside of the drum.
3. Remove old Cable Assembly and attach new
one.
4. Rotate the clutch cap to the “Engage”
position.
5. Retract Cable Assembly onto drum being
careful not to allow kinking or over heating of
the winch.
Maintenance
Motor
Periodically, when not used very often, or after
wet / damp conditions, be sure to run the motor in
free spool until the motor is warm. This helps dry
out any moisture and condensation trapped inside
the housing.
