5
RTB SERIES CABLE REEL MANUAL
SECTION 2 - SAFETY
Call: 1-716-312-0088
Electrical Warnings
Properly ground this equipment before use in accordance with both the National Electric Code and local
electrical codes and ordinances.
Disconnect the electrical power from the cord reel before any service functions are performed.
Do not use this cord reel for loads greater than the current rating listed on the label and voltage greater than
300V with SJOW-A cable OR 600V with SOW-A cable. The ampacity (current) rating of the cable must be in
accordance with the National Electric Code.
Electrical wiring on the reel must be done by a qualified electrician.
Operational Warnings
Exercise care when handling the cord reel during normal operation. This cord reel has a rotating spool
powered by springs under tension.
Do not allow cable to retract without restraining the retraction speed.
Do not disassemble the spring motor for any reason. Serious personal injury could result. This cord reel is
equipped with springs under tension. Contact the factory for assistance:
Maintenance Warnings
Do not use cable different from that for which the reel is intended. Changes in diameter, weight per foot,
length of cable or flexibility will affect the operation of the reel.
Mounting hardware and fasteners should be installed to maintain tightness under vibration and checked
periodically to assure tightness.
Overhead installation mountings should be such that the reel is not suspended by bolts in tension. A safety
chain or cable is strongly recommended to minimize damage and/or possible injury in the event of mounting
failure.
WARNING
: Modification of this equipment may cause excessive wear and will void the warranty. Contact the
manufacturer regarding changes or modifications of equipment which could affect reliability or safety.
