Procedure to connect to the Encoder via the remote setup port
The following procedure will allow the installer to setup the Encoder via the GUI
(Intranet setup- closed LAN setup)
1.
Power up the Encoder.
2.
Press the OK button on the Front Panel.
3.
Enter the Password 0000 to enter Advanced Menu Setup.
4.
Scroll to the Device Address Menu.
5.
Set a unique Device address for each encoder being installed in the system.
Device Address ranges from 1~255
Warning: Setting the “DEVICE ADDRESS” to 0 will clear the network setting to the
Factory Default value.
6.
Connect each encoder using a standard CAT5e cable from the Remote Setup port
(located on the rear panel of the encoder) to a switch. Connect a CAT5e cable from the
switch a PC.
NOTE: To connect to the encoder directly to a PC use a CAT5e Crossover cable
7.
Set the PC via the Control Panel to
“Obtain an IP address automatically”
Start- Control Panel
View Network Status and Tasks
HDM-1000/2000/4000 Manual V1.0
13
