Integration
instructions
for
host
product
manufacturers
according
to
KDB
996369
D03
OEM
Manual
v01
2.2
List
of
applicable
FCC
rules
CFR
47
FCC
PART
15
SUBPART
C
has
been
investigated.
It
is
applicable
to
the
modular
transmitter
2.3
Specific
operational
use
conditions
This
module
is
stand-alone
modular.
If
the
end
product
will
involve
the
Multiple
simultaneously
transmitting
condition
or
different
operational
conditions
for
a
stand-alone
modular
transmitter
in
a
host,
host
manufacturer
have
to
consult
with
module
manufacturer
for
the
installation
method
in
end
system.
2.4
Limited
module
procedures
Not
applicable
2.5
Trace
antenna
designs
Not
applicable
2.6
RF
exposure
considerations
This
equipment
complies
with
FCC
radiation
exposure
limits
set
forth
for
an
uncontrolled
environment.
This
equipment
should
be
installed
and
operated
with
minimum
distance
20cm
between
the
radiator
&
your
body.
2.7
Antennas
This
radio
transmitter
FCC
ID:
2A8Q4-VIM1S
has
been
approved
by
Federal
Communications
Commission
to
operate
with
the
antenna
types
listed
below,
with
the
maximum
permissible
gain
indicated.
Antenna
types
not
included
in
this
list
that
have
a
gain
greater
than
the
maximum
gain
indicated
for
any
type
listed
are
strictly
prohibited
for
use
with
this
device.
Antenna
No.
Operate
frequency
band
Antenna
Type
Maximum
antenna
gain
Antenna
0
2400-2500MHz
5000-6000MHz
FPC
Antenna
2.47
dBi
For 2.4GWIFI
1.71dBi For 5.2GWIFI
3.93dBi For 5.8GWIFI
2.8
Label
and
compliance
information
The
final
end
product
must
be
labeled
in
a
visible
area
with
the
following"
Contains
FCC
ID:
2A8Q4-VIM1S
".
2.9
Information
on
test
modes
and
additional
testing
requirements
Host manufacturer which install this modular with single modular approval should perform the test of radiated emission and
spurious emission according to FCC part 15C:15.247/FCC part 15E:15.407 and 15.209 requirement, only if the test result
comply with FCC part 15.247/FCC part 15E:15.407 and 15.209 requirement, then the host can be sold legally.
2.10
Additional
testing,
Part
15
Subpart
B
disclaimer
Host
manufacturer
is
responsible
for
compliance
of
the
host
system
with
module
installed
with
all
other
applicable
requirements
for
the
system
such
as
Part
15
B.
