10
Chair Width
Non-Folding Frame
NOTE: Adjusting the width also affects any seating, seat pan, rigidizer handle and rigidizer bar that
may be present. See those corresponding sections, if applicable, for instructions on how to
disassemble.
1. The crosstubes (B) are detached from the crosstube extensions (D) by removing the two bolts (A), four
washers (C) and two nuts (E) using two 10mm wrenches.
2. The crosstubes (B) are detached from each other by removing the bolt (F), two washers (G), two
saddles (H) and the nut (I) using two 13mm wrenches.
3. Reassemble the crosstube assembly using the diagrams and table below to achieve the desired width
configuration.
A
B
C
D
C
E
F
G
H
H
D
C
E
C
B
A
I
G
A
B
C
A
B
C
A B C
Configuration Hole Set to Align Cross Tube
Cross Tube
Extension
10W Small
A
11W Small
B
12W Small
C
12W Medium
A
13W Medium
B
14W Medium
C
14W Large
A
15W Large
B
16W Large
C
16W XL
A
17W XL
B
18W XL
C
XL
XL
Small
Small
Medium
Medium
Large
Large
Always use the 1st and
3rd holes to attach for
Non-Folding Frame. Do
not use center hole.
A
B
C
