54
Rigidizer Handle
1. Install the spring (J) into the latch (D).
2. Insert the barrel nut (I) into the latch (D) and align the threaded hole in the barrel nut with the hole in the
latch.
3. Insert the latch pin (M) through the hole in the latch (N) which will compress the spring (J).
4. Align the hole in the latch pin (M) with the slot in the latch. Fasten pin in place with screw (K) and button
latch (L) using a 3mm Allen wrench. Do not overtighten which would cause binding.
5. Insert the pivot adapter (B) into the pivot (D). Secure in place with E-Clip (C).
6. If foam grips (G) are not on, apply isopropyl alcohol to the inside of the foam grips and slide onto the
latch and pivot aligning the holes in the grips with the latch and pivot holes.
7. Insert the cross tube (H) into the latch and pivot and secure with screws (E) and lock washers (F) using
a 4mm Allen wrench.
NOTE: See the table below to determine the holes used when installing the cross tube.
8. Insert the pivot into the right push handle of the backrest and secure with screw (A).
9. Insert the latch adapter into the left push handle of the backrest and secure with screw (A).
10. Verify the function of the latch before use.
Hole Configuration for Chair Width
Chair Width
Cross Tube (H)
Hole A + Hole A
Hole A + Hole B
Hole B + Hole B
10 - 12W (offset handles)
110264
10
11
12
12 - 14W (offset handles)
110265
12
13
14
14 - 16W
110264
14
15
16
16 - 18W
110265
16
17
18
A
B
A
B
A
B
C
D
E
F
G
H
I
J
K
L
M
Holes in Cross Tube (Callout H)
O
N
Offset Handles
