56
Hemi Wheel Lock
NOTE: These instructions show installation of the master/drive side being on the right side. The
steps are the same, but flipped if the user wants the master/drive side being on the left side.
1. Install the master assembly (A) onto the right wheel lock mount (B) with two nuts (C) using a 10mm
wrench.
2. Install the master assembly and wheel lock mount assembly onto the frame with a bolt (F), lock washer
(E) and a flat washer (D) using a 10mm wrench.
NOTE: Slide the master assembly and wheel lock mount assembly along the frame so the front most
nut (C) is approximately 1/4" from tire. Once in position, secure by tightening to 144 in/lbs.
3. Insert the follower assembly (H) to the left wheel lock mount (G) with two nuts (C) using a 10mm
wrench.
4. Install the follower assembly and wheel lock mount assembly onto the frame with a bolt (F), lock
washer (E) and a flat washer (D) using a 10mm wrench.
NOTE: Slide the follower assembly and wheel lock mount assembly along the frame so the front
most nut (C) is approximately 1/4" from tire. Once in position, secure by tightening to 144 in/lbs.
A
B
C
D
E
F
G
H
R
I
A
H
C
F
O
T
N
O
R
F
Master/Drive Assembly
Down Reverse
(Use on Extended Frame)
Down Forward
(Use on Standard Frame)
