12
Caster Angle and Squaring
To maintain optimal performance of your Rogue, the front caster housing should always be aligned
perpendicular to the ground. Your Rogue is shipped aligned. It is recommended that caster squareness is
checked after making adjustments to the chair configuration related to any of the following items: caster
size or type, camber, rear wheel, tire, center of gravity and seat heights. Caster squareness should always
be the last check made prior to use after adjustments or changes to the chair have been made.
After all other adjustments are made you should check your caster housing alignment and realign if the
housing is not perpendicular to the ground.
Adjusting the Caster Angle:
For optimum performance, the caster housing should always be at 90° angle to the floor (perpendicular to
the ground).
1. To change the angle, you will need an M5 Allen wrench.
2. Loosen the M8 button head screw (A) on the bottom of the caster housing wing. Turn the screw on the
top of the caster housing wing (B). Loosening will begin to tilt the caster forward. By tightening, you will
turn rearward.
3. Turn until you have aligned the caster stem so it is perpendicular to the floor.
4. Place a large right triangle against the flat surface of the fork as shown.
5. With the rack and pinion system of the Rogue, the casters should always be able to be square.
A
B
