54
Wheel Locks
Installing Wheel Lock Clamps
1. The wheel lock assemblies with the wheel lock bars are mounted onto the chair using the wheel lock
clamps (C & D). There are two types of wheel lock clamps that are shown below. Install hardware with
the wheel lock bar and chair frame in position using a 5mm Allen wrench and a 6mm Allen wrench.
Once installed, ensure wheel lock engages at least 1/8" into tire and locks properly prevent the chair
from moving when engaged.
NOTE: Always tighten wheel lock hardware by alternating between hardware while tightening a little
at a time. This prevents overclamping on one set of hardware which can lead to binding of the
fasteners and increased diffculty in removal.
Smaller Clamp
(1.125”)
A
B
C
D
