35
Hand Tilt Mechanism Installation
NOTE: Remove any seating / cushion on the chair along with the seat pan for access in later steps.
1. Fully thread the cable (G) onto the housing plunger (F) until the ball end of the cable emerges from the
end of the plunger (F).
2. Install the spring (D) onto the end of the plunger (F) and hook the pin (E) onto the ball end of the cable
(G).
3. Thread the cable assembly into the plunger adapter (A).
4. Install the plunger adapter assembly onto the tilt plate and secure with two washers (B) and two nuts
(C) using a 10mm wrench.
Routing Cable
1. Install the P-Clip (B) to the rotary frame with the bolt (A) and nut (C) using two 10mm wrenches.
NOTE: If the chair CG setting is 1 or 2, install the P-Clip under the front nut of the adapter plate. If
not, always install in the frontmost hole.
NOTE: The cable is routed over and around the bearing strut, but above the rotary frame strut as
shown in the image below. Cable routing is more clearly shown on the next page also.
A
B
C
D
E
F
G
A
B
C
