37
Foot Tilt Mechanism Installation
NOTE: Remove any seating / cushion on the chair along with the seat pan for access in later steps.
1. Fully thread the cable (G) onto the housing plunger (F) until the ball end of the cable emerges from the
end of the plunger (F).
2. Install the spring (D) onto the end of the plunger (F) and hook the pin (E) onto the ball end of the cable
(G).
3. Thread the cable assembly into the plunger adapter (A).
4. Install the plunger adapter assembly onto the tilt plate and secure with two washers (B) and two nuts
(C) using a 10mm wrench.
Installing Foot Tilt Pedal
NOTE: An image of the correct cable routing is located on the next page. Reference the image
before installing the cable into the foot tilt pedal.
1. Install the cables (G) into the nut plate (E) and the foot pedal (F).
2. Install the covers (D & H) over the cable and foot pedal assembly and onto the foot mount (C) with two
bolts (I) and two nuts (B) using a 5mm Allen wrench and a 10mm wrench.
3. Install the foot mount assembly onto the rear strut tube with a bolt (A) and nut (B) using a 5mm Allen
wrench and a 10mm wrench.
A
B
C
D
E
F
G
A
B
B
C
D
E
F
G
H
I
Chair Width
Same Side Cable Opposite Side Cable
14 - 18
Standard
Standard
19 - 22
Standard
Medium
14 - 18 (Recline)
Medium
Medium
19 - 22 (Recline
Medium
Long
Foot Tilt Cable
*Same side cable is the cable that goes from foot pedal
to the same side of the chair that the foot pedal is
mounted on.
