55
Attendant Foot Lock
4. Route cable as shown below. The cable is attached the lock assembly by inserting the cable barrel into
the hole called out below from the opposite side of the lock. The keyhole barrel nut is installed into the
slot called out below. Adjust the cable adjuster until the cleat is approximately 1/8" away from the tire.
Tighten the jam nut against the barrel to secure. Always check the lock engages and disengages
properly with no user in the chair.
Adjust cable adjuster until the cleat is approximately
1/8” away from tire. Tighten the jam nut against the
barrel to secure.
Insert
keyhole
barrel nut
into slot.
Insert cable
barrel in this
hole from
the opposite
side of lock.
Route cables below base
frame for “DOWN” axle plate
configurations and above
base frame for “UP” axle plate
configurations.
