KI WorkZone Series, Assembly Instructions Manual

4

Assemble units as described herein only. To do otherwise 
may result in instability. All screws, nuts and bolts must be  
tightened securely and must be checked periodically after  
assembly. Failure to assemble properly, or to secure parts 
may result in assembly failure and personal injury.

WorkZone

®

 Single Universal Overhead Cabinet

Assembly Instructions

4. Position cabinet back as illustrated, 

with studs facing the rear. Orient 

the cabinet back into position, 

inserting the studs on the cabinet 

back through the mounting holes in 

rear flanges of both installed cabinet 

sides. Use six #10-24 serrated nuts 

to secure back to sides (Figure 2).

5. Place the shelf bottom into position 

between the cabinet sides, above the 

lower mounting flanges and tight 

to the installed shelf back. Nest the 

bottom shelf down onto both cabinet 

sides lower mounting flanges and 

align mounting holes. Secure the 

bottom shelf to the cabinet sides 

from underneath, at each end using 

two #8-32 x 

1

/

2

” screws (Figure 3).

6. At the lower rear of the shelf back, 

secure the shelf back to the rear edge 

of the bottom shelf using two 

  #8-32 x 

1

/

2

” screws (Figure 3).

Figure 2

cabinet side

(right-hand)

cabinet side

(left-hand)

right-hand

stanchion

left-hand

stanchion

WorkZone

Desk

#10-24

serrated nut

#10-24

serrated nut

cabinet

back

cabinet side

(right-hand)

cabinet side

(left-hand)

right-hand

stanchion

left-hand

stanchion

cabinet

back

#8-32 x  /

1

2

"

screw

Figure 3

#8-32 x  /

1

2

"

screw

shelf

bottom