Picture 6
Fresh Water Tank
Usage
Wet Cleaning
Remove the motor head from the lower body.
Take off the cartridge filter and fit sponge filter (Picture 4).
After fitting the filter, rotate the filter lock clockwise until it is locked in
place.
Remove the vacuum bag
Place the waste water bucket into the lower body, aligning the hose
inlets of the body and bucket.
Connect the vacuum hose into the socket at the front of the main
body.
Connect one end of the transparent detergent pipe to the carpet tool
by pushing and twisting the lateral latch.
Connect the stainless steel telescopic wand between the carpet tool
and the trigger mechanism. The carpet tool is located onto the wand
via the push button mechanism.
Connect the other end of the transparent detergent pipe into the
detergent connector on the trigger mechanism by pushing and
twisting the lateral latch.
Fill the fresh water tank up to a maximum of 7 litres. Cold or warm
water up to 30°C can be used, never use hot water.
Add detergent into the fresh water tank, quantity is as per instructions
on detergent packaging (Picture 6).
Ensure the filter at the end of the detergent pipe which connects to
the tank of the machine (Picture 7) is fitted. This filter should be
cleaned if contaminated, using the machine without the filter will
damage the pump.
Switch on the pump and depress the trigger on the handle to spray
water, always switch the pump off when not in use. Switch on the
motor to vacuum up the water. For best results, vacuum up any
debris before spraying water on.
Picture 4
Fitting sponge filter
Picture 5
Carpet Tool
Picture 7
Process of sucking water out of fresh water tank
