- 3 -
Ⅱ
.Starting and operating of the machine.
Check that the electrical switch is switched off(in positon 0).Then connect the
suction hose into the suction inlet at the machine by pushing the hose forward
until it snaps in place at the inlet(to release the hose from machine just push the
release button downwards and then pull out the hose). Then connect the two tubes
with the hose connector,twist the tubes in order to ensure that they are properly
fitted. Attach suitable nozzle to the tube.Choose nozzle depending on what type of
material that is to be picked-up.Connect the plug into a proper electrical outlet.Put
the electrical switch into position 1 in order to start the motor. The machine have
two motors,two electrical switches—one switch for each motor.
Note ! wet picke up.
The machine is equipped with a float body that shuts of the airflow through the
machine when the maximum liquid level is reached. You will then hear a
noticeable change of the sound from the motor and notice that the suction power
decreases. When this occurs,switch the machine off. Disconnect the machine from
the socket. And emptying the tank.
Ⅲ
.
Emptying afer wet pick up.
Before emptying the container,unplug the vacuum cleaner. Always empty and
clean the container and the float system after picking-up liquids.Never pick up
liquid without the float system installed in the machine.
Emptying
RJC-15,RJA-30H
a).Release the latch by pulling the lower parts outwards so that the motor top is
released.Lift up the motor top.
b).Disconnect the hose from the inlet y pressing the button on the hose connection
downwards. Then pull out the hose.
c).Empty by tilting the container backwards and pour the liquids into a floor drain
or similar. Wipe the float valve and float basket with a damp cloth before the
motor top is reinstalled to the container.
d)Put back the motor top to the container. Secure with the latches.
Emptying: RJA-80P
e).
Drain hose:
The model RJA-70P have a draining hose. Detach the drain hose
from the bracket by pulling hose forwards from the cleaner.Place the drain hose
end near a floor drain and then remove the plug at hose end. The natural pressure
will then drain the liquids from the container.
f)
.Emptying from the container
:Pull the upper parts of the latches outwards and
release the motor top.Remove the motor top.The suction hose can be attached
during emptying from the container.Grasp with one hand at the handle at the lower
part of the container. To avoid movement of the trolley-place one foot at the
basepart of the trolley.Then tilt the container backwards and pour the liquids.
g).Wipe the float valve and float basaket with a damp cloth before the motor top is
