31
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS .
*IF EQUIPPED
OTHER KEY FEATURES
•
• You can reprogram a single HomeLink
®
button by repeating Step 2
• Erasing programmed buttons will delete all trained transmitters
QUICK
TIPS
How to Sync Transmitter with HomeLink
®
*
Erasing programmed buttons:
If programming for the first time, begin with Step 1
(repeating this step will delete all information) .
To program non-rolling and rolling code garage door
openers and other devices:
1 . Press and hold the left
A
and center
D
buttons
simultaneously until the indicator light
C
begins to
flash (to reprogram buttons, skip this step)
2 . Press and hold the desired button
A
B
D
and hold
the button on the transmitter while it is approximately
1 to 3 inches away from the mirror . The HomeLink
®
Indicator light
C
will flash rapidly once the frequency
signal has been successfully programmed
To finish programming rolling code garage door openers,
complete these steps:
3 . Locate the “learn” or “smart” button on the garage
door’s motor head unit . Press and release the button
and complete Step 4 within 30 seconds
4 . Firmly press and release the programmed HomeLink
®
button up to three times
Press and hold the left
A
and center
D
buttons
simultaneously for approximately 20 seconds,
and then release both buttons within 30 seconds .
Operating HomeLink
®
:
Press one of the programmed HomeLink
®
buttons .
REMINDER:
Mirror indicator light
C
will illuminate when automatic
dimming is ON .
If your garage door opener was manufactured in 2011 or later, and you’re unable to program your vehicle’s HomeLink
®
system, you may need to
purchase a HomeLink Repeater Kit. For more information, go to www.HomeLink.com or call (800) 355-3515.
The HomeLink
®
/ Auto-Dimming Rearview Mirror* is
designed to reduce glare from a vehicle’s headlights
located in the rear and also connect up to three electronic
transmitters into one location .
• To turn automatic dimming ON, press button
F
• To turn automatic dimming OFF, press button
G
HomeLink
®
with Auto-Dimming
Rearview Mirror*
A
HomeLink
®
button
B
HomeLink
®
button
C
Indicator light
D
HomeLink
®
button
E
Glare detection sensor
F
Automatic dimming ON
G
Automatic dimming OFF
A
B
C
D
E
F
G