INSTALLING THE LIGHT KIT AND GLASS
CAUTION:
off at the main circuit breaker or by removing the circuit fuse. Turning the power
Before continuing installation, confirm that the power is still turned
off using a wall switch is not sufficient to prevent electrical shock.
Step 1.
Hold the light kit close to the switch housing and connect the WHITE
wires from the light kit and fan by pushing the connectors together. Follow the
same procedure with the BLACK wires. (Fig. 20)
Step 2.
Tuck the connections neatly into the light kit. Remove one of three
screws pre-installed on the switch housing and keep for later use. Loosen the
other 2 screws (do not remove). Place the two slot holes on the light kit over
the 2 screws previously loosened from the switch housing. Rotate the light kit
until it locks in place at the narrow end of the key holes. Secure by tightening
the 2 screws previously loosened and the one previously removed. (Fig. 20)
Step 3.
Secure the glass to switch housing by twisting in a clockwise direction,
twist the glass gradually until it snaps on to the switch housing. Do not over -
tighten. (Fig. 21)
Glass
Fig. 20
Fig. 21
Light Kit
14 | KICHLER.COM
