ASSEMBLY INSTRUCTIONS
12
14.Connect wires from the motor assembly (F) to the light kit (H). Remove 1 of 3 screws from the
light kit housing (G) and loosen the other 2. Position keyhole slots around the screws and twist
clockwise. Insert the screw that you had previously removed. Tighten all screws.
Note: White wire connects to white wire and black wire connects to black wire.
H
G
14
F
H
I
15
15. Insert 60-watt max candelabra bulb (I) into the
socket found on the light kit (H). When necessary,
replace with bulbs of the same wattage.
CAUTION:
An energy-saving wattage limiter is
included in the receiver of the fan. When replacing
bulbs, ensure bulb wattage is below 190 watts,
otherwise the item will not function.
WARNING:
To reduce risk of burns, eye damage, or
electrical shock, disconnect power and allow bulb to
cool for at least 5 minutes before replacing. Do not
touch the bulb or look directly at the lamp when in
use. Replace glass/shade/diffuser if broken.
