9
10
ASSEMBLY INSTRUCTIONS (DIRECT WIRE MOUNTING)
5b. Remove coupling (F) from the bottom of
canopy (A) by unscrewing the hex nut
from the short threaded pipe protruding
into the canopy (A). Discard the coupling
(F), short threaded pipe, hex nut, and lock
washer.
Insert hole cover (II) into hole from the
outside of canopy (A) such that bottom
of hole cover (II) is flush with bottom of
canopy (A) when installed.
5b
6b. Split the end of the cord and strip ends of
each wire 1/2" (13mm).
6b
0.5"
[13mm]
11
REMOVE AND
DISCARD
Hardware Used
x 1
Hole Cover
II
A
F
A
II
