10
Unscrew the jack tool-bag knob and remove the tool-bag. Fig 31
Remove the bolt indicated in Fig 31
Install the module relocation bracket as shown in Fig 32 and reinstall bolt.
There are two lower subwoofer brackets provided depending on the wheelbase of the vehicle. For
Tahoe/Yukon use the longer bracket. For Suburban/Yukon XL use the shorter bracket. Determine the
lower subwoofer bracket needed and attach it to the subwoofer using the supplied nut and bolt as
shown in Fig 33
Note: The lower subwoofer bracket should overlap the bracket attached to the
subwoofer as shown. The nut should be installed on the side closest to the
subwoofer. Leave the nut and bolt slightly loose so the lower bracket can slide.
Remove the nut that secures the jack bracket indicated in Fig 34
Pull the factory wire harness slightly away from the metal in order for the subwoofer upper bracket to
pass under the factory wire harness. Fig 35
Hold the subwoofer at about a 45-degree angle and slide the lower subwoofer bracket over the jack
stud. Fig 36
Fig 33
Fig 31
Fig 36
Fig 34
Fig 35
Fig 32
