4
Install the black two pin power connector on the subwoofer power harness by first inserting the terminal
fully into the connector and then depressing the blue retainer. Fig. 4
Note: Make sure the blue retainer in the center of the
connector is not depressed – it should be flush with
the front of the connector. If the retainer is
depressed, the terminal will not fully seat in the
connector body. Make sure the terminal is installed
into position 1 on the connector body. There should
be a block-out plug installed in position 2 in order to
prevent the terminal from being installed into the
wrong position on the connector.
Using a panel removal tool, pry loose the driver’s side front and rear threshold panel along the bottom of
the door openings. Fig. 5 & 6
Pry loose the dash end panel on the driver’s side. Fig. 7
Remove the two screws securing the side of the panel below the steering column. Fig. 8
Fig 8
Insert
terminal
first
Then
depress
blue
retainer
Fig 4
Fig 6
Fig 5
Fig 7
