5
Remove the two screws securing the bottom of the panel below the
steering column and pull the panel loose. Fig 9
2017 Year Model Only – Module Relocation
(for all other year models, proceed to step 15
)
Note: 2017 Year Model vehicles require the relocation of a module in order to gain
sufficient space to mount the amplifier. Follow steps 11-14 to relocate the factory
module.
Remove the two screws securing the factory module bracket under the driver’s side dash and pull the
module and bracket down. Fig.10
Secure the module to the provided relocation bracket exactly as shown in Fig.11.
Remove the four nuts securing the knee bolster under the steering column. Fig.12
Install the relocation bracket and module over the knee bolster studs as shown in Fig.13. Reinstall the
knee bolster and reinstall nuts and tighten to 9Nm. Secure the module wire harness by inserting the
factory wire retainer into the hole on the bottom of the relocation bracket.
Fig 9
Fig 10
Fig 11
Fig 12
Fig 13
