9
Locate the factory module bracket and remove the two nuts securing it. Fig 27
Pry the module wire retainers from the factory bracket. Fig 27
Note: Depending on the vehicle trim level, there may be one or two modules
attached to the bracket. The module(s) will need to be relocated using the
supplied relocation bracket in order for the subwoofer to be installed.
Note: Do not disconnect the module wiring. Modules wiring is shown
disconnected in some pictures only for clarity of installation.
Pry out the center portion of the plastic retainer securing the smaller module and then the outer portion.
Remove the module from the factory bracket. Fig 28
If equipped, remove the larger module by snapping it out of the factory bracket.
Pull the factory module bracket from the metal and discard.
If equipped with two modules, slide the larger module into the relocation bracket first as shown in Fig 29
Using the supplied bolt and plastic fastener, install the smaller module over the top of the larger module
as shown in Fig 30
Note: The connectors on the smaller module face the opposite direction as the
connectors on the larger module. The smaller module mounts the same way
regardless of whether or not there is a second module.
Fig 27
Fig 28
Fig 29
Fig 30
