10
Disabling Active Noise Cancellation (ANC)
1.
Using a panel tool, remove the screw cover from the driver’s side visor. Fig. 1
2.
Remove the three screws securing the visor, pull visor loose and disconnect wiring.
3.
Open the screw covers on the grab handle above the driver’s door, remove the two screws and pull loose
handle. Fig. 2
4.
Snap loose the driver’s side A pillar cover slightly. Cover doesn’t need to be completely removed. Fig. 3
5.
Pull down the rubber door seal along the top of the driver’s door. Fig. 4
6.
Pull down slightly on the headliner to expose the black adhesive tape covering the microphone.
7.
Carefully remove the black tape so that it can be re-applied. Fig. 5
8.
Find and disconnect the microphone wiring. Disconnecting just one of three microphones will disable the ANC.
Fig. 6
9.
Re-apply the black adhesive tape over the microphone and connecters.
10.
Re-install previously removed parts in reverse order.
Fig. 2
Fig. 1
Fig. 4
Fig. 3
Fig. 6
Fig. 5
