12
13
Battery Replacement and Disposal
The battery will eventually lose the ability to hold a charge.
Depending on the amount of use, and varying conditions, the
battery should operate for one to three years. Follow these steps
to replace and dispose the battery.
Important! Recycle the dead battery responsibly. The battery
contains lead acid (electrolyte) and must be disposed of properly
and legally. It is illegal in most areas to incinerate lead acid
batteries or dispose of them in landfills. Take it to a federal or
state-approved lead acid battery recycler, such as an authorized
service center or your local automotive battery retailer. Do not
throw the battery away with your regular household trash!
Maintenance
Service
The ride-on toy should be checked for damage, missing or badly
worn parts before each use.
• Check the tightness of the fasteners before each use.
• Check the tightness of the wheels before each use.
• Ensure the battery is securely in place before each use.
• Store the ride-on toy indoors or cover it with a tarp to protect it
from the wet weather. Keep it away from sources of heat, such as
stoves and heaters.
• Do not leave the vehicle in the sun for long periods of time or
fading may occur. Store in shade or cover with tarp.
• Do not wash the vehicle with a hose.
• Do not wash the vehicle with soap and water.
• Clean the vehicle with a soft, dry cloth. To restore shine to plastic
parts, use a non-wax furniture polish. Do not use car wax,
abrasive cleaners or wash the vehicle with soap and water. Water
will damage the motor, electrical system and battery.
Do not return this product to the place of purchase. If your ride-on
toy needs service, repairs or replacement parts, call:
Pacific Cycle Consumer Relations
Hours: 8:00 am – 5:00 pm (CST) Monday - Friday
Phone: 877-741-6154
Email: customerservice@kidtraxtoys.com
For a complete list of replacement parts, please contact
Pacific Cycle Consumer Relations. To order parts, please have
the model and serial number available, which can be found
underneath the seat on the battery cover.
FCC Statement
Any changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This ride-on toy contains a sealed
lead acid NON SPILLABLE BATTERY.
This battery must be recycled.
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Non-rechargeable batteries are not to be recharged. Batteries are to be inserted with the correct polarity. Exhausted batteries are to
be removed from the toy. The supply terminals are not to be short-circuited. Rechargeable batteries are only to be charged under
adult supervision.
• Rechargeable batteries are to be removed from the toy before being charged.
Remote Control Use and Functions
WARNING
Pairing the remote control to the ride-on
Insert the batteries
Press the left button to
turn left.
LED Indicator lights
Frequency button
Reverse button
Forward button
❶ Press the frequency button for 2-4 seconds until the LED on
the remote control flash.
❷ Press the power button on the car. The battery indicator
lights will flash through a sequence.
Note: If the battery indicator lights on the car do not go through
a lighting sequence, the remote control is not paired.
Repeat steps 1 - 2.
❶ Remove the small screw from the battery compartment cover.
❷ Insert two AAA-size batteries into the battery compartment
as shown.
❸ Replace the battery compartment cover and fasten with the
small screw you removed in step one.
❷
❸
❶
❶
❷
Emergency stop button
Press the right button to
turn right.
