6
7
Assembly
Follow the assembly steps in the order listed below.
❶ Attach the left and right front wheel assembly to the
front axle.
❷ Cut the zip tie to remove the gear box from the rear
axle. Insert the gear box into the gear box opening in
the wheel well.
❸ Insert the rear axle completely through the left, rear
wheel well.
❹ Attach the left and right rear wheel assembly to the rear
axle.
❺ Insert the steering wheel over the end of the steering
column. Secure with the nut and bolt. Note: Connect the
wire connector from the steering wheel to the wires
connector coming from steering column.
❻ Insert the wings into the wing slot on each side of the
body.
❼ Connect the wires located underneath propeller base
and on top of the propeller base slot.
❽ Insert the propeller into the propeller base. Then insert
the propeller assembly down into the body.
❾ Insert the rear propeller assembly into the inset on the
back of the body.
❿ Charge the battery (see charge the battery instructions
on page 9).
⓫ Fasten the seat to the body and lock into place.
❶
❶
Insert the hubcap
tabs into the 4 slots
on the wheel inset.
To tighten the wheel
bolts, place a wrench on
each wheel bolt and
simultaneously turn the
wrenches in the
opposite directions until
the bolts are tight.
❹
❹
Remove the nut
and bolt from the
steering wheel
BEFORE performing
Step 5.
❸
❻
❾
❿
❻
❽
❼
Be sure the gear box and wires
are completely inserted through
the gearbox opening.
❺
