6
Adding an additional wireless unit
This process is to enrol additional wireless bases to an existing
system.
1. Install and power up the new unit. The Amber and the Green
LED of the new wireless base will both be on.
2. Go to the master alarm. (See section 1 above to recognise a
master and remote RF wireless base).
3. Press the enrol button for 1-2 seconds on the master RF wireless
base. The amber LED will flash on for 2 seconds and off for 2
seconds. It is ready to enrol a new remote wireless base.
4. Press the enrol button for 1-2 seconds on the new remote alarm
RF base. The amber LED on the wireless base will flash on for 2
seconds and off for 2 seconds. When the master unit invites it to
join the amber LED on the remote wireless base will flash 1-6
times every 4 seconds.
5. Press the enrol button on the new remote to complete the process.
The amber LED will blink rapidly indicating the remote has
completed the enrolment process.
6. Return to the master unit and press the enrol button a second time
to set the system.
Removing a wireless unit.
NOTE: Alarms can be replaced without replacing the wireless
base.
1. If a wireless base needs to be removed from the system, remove
power from the unit to be removed and wait for 5 minutes for the
master unit to recognize the error. Go to the master unit (see sec-
tion 1 as to how to distinguish between the master and remote RF
units) and verify that the amber LED is flashing (or on
continuously if there is only two units in the system). Press the
enrol button on the master RF wireless base. The amber LED will
begin to flash on for two seconds and off for two seconds.
2. Press the enrol button on the master unit a second time to finalise
the new system.
Resetting unit to factory condition.
The wireless base may be reset to the factory settings at any time by
pressing both buttons for ten(10) seconds. (this may be helpful if
there is confusion during enrollment or if the base is being relo-
cated).
1. Press and hold the function button before pressing the enrol but-
ton.
2. While holding the function button press the enrol button and hold
both until the amber LED flashes rapidly 10 times and then
remains lit.
1209-7201-02(21008418)_V2:_ 2011.4.19 9:13 AM Page 7
