Step 32: Attach Exit End Assembly to Fort
Hardware
8 x
1/4 x 3/4” Pan Bolt
(1/4” lock nut)
PB1
Other Parts
2 x TNR2 Slide Clamp Ring
Bottom Slide Bolt Holes
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
PB1
Lock
Nut
Fig. 32.3
Make sure arrows
are aligned
Fig. 32.2
Elbow
Assembly
Top Slide Bolt Holes
Fig. 32.1
Exit Elbow
Assembly
PB1
Lock Nut
Lock Nut
PB1
Note: When installing Pan Bolts make sure to
look at holes so bolts go through the side with the
round recess and the lock nuts go through the side
with the hexagonal recess. Keep all bolts loose
until further step.
A:
Fit the Exit End Assembly to the last Elbow
Assembly by lining up the arrows on each assembly.
Notice the elbow orientation. (fig. 32.1)
B:
Place 1 TNR2 Slide Clamp Ring to the top of the
joined Assemblies, rotate counter clockwise 1 hole
location then attach with 3 (PB1) 1/4 x 3/4” Pan Bolts
(with lock nut) as shown in fig. 32.1.
Use Quadrex Driver as a guide pin for each hole
before inserting bolt.
C:
Attach 1 TNR2 Slide Clamp Ring to the bottom of
the joined Assemblies using 3 (PB1) 1/4 x 3/4” Pan
Bolts (with lock nut) as shown in fig. 32.2.
D:
Connect the 2 TNR2 Slide Clamp Rings together
in 2 spots using 1 (PB1) 1/4 x 3/4” Pan Bolt (with lock
nut) per hole. Make sure seams and arrows line up and
then tighten all bolts. (fig. 32.3).
77
Summary of Contents for Cedar Summit Canyon Ridge
Page 113: ...NOTES 113 ...
