127
Step 69: Attach TNR 4 Slide to Adventure Tower
A:
On the fourth attached Elbow Assembly remove the pan bolt and nut which is facing the tower (installed previously
Step 62). (fig. 69.2)
The bolt will no longer be needed, but keep the lock nut.
B:
Loosely attach TNR3 Tube Support (at the slightly bent end) to the slide seam using 1 (PB6) 1/4 x 1” Pan Bolt (with
flat washer and the previously removed lock nut). (fig. 69.1)
C:
Rotate TNR3 Tube Support and attach to (6002) Long Post using 1 (S6) #12 x 1” Pan Screw as shown in (fig. 69.1.)
D:
Fully tighten screw and bolt.
Fig. 69.2
Fig. 69.1
Remove PB1 (1/4 x 3/4”
Pan Bolt) first then install
PB6 (1/4 x 1” Pan Bolt
with flat washer)
6002
S6
Lock
Nut
Flat
Washer
PB6
Note: Flat
end down
TNR Brace
Assembly
6002
Hardware
1 x
#12 x 1” Pan Screw
1 x
1/4 x 1” Pan Bolt
(1/4” flat washer & 1/4” lock nut - previously removed)
PB6
Other Parts
1 x TNR3 Tube Support
S6
TNR3 Tube
Support
