30
Hardware
8 x
1/4 x 2-1/2” Wafer Lag
WL5
Back Wall
End Wall
Swing Wall
Front Wall
Step 4: Frame Assembly
Part 2
B:
Place End Wall from Step 3 between the Front Wall and Back Wall noticing the wall orientation. The tops
and bottoms of the walls should be flush. Make sure the walls are square then using the pilot holes as a guide
predrill with a 3/16” (4.8 mm) drill bit and fasten the Back Wall to the End Wall and End Wall to the Front Wall
with 4 (WL5) 1/4 x 2-1/2” Wafer Lags per side. (fig. 4.4)
Fig. 4.4
Notice Back Wall
overlaps End Wall
Notice End Wall
overlaps Front Wall
WL5
