4.
Insert the Slide Legs through the Slide Ladder Steps.
Important:
parallel to the ground. Slide the step through the Slide Legs at the
same angle as the holes in the Steps.
5.
Fasten the Slide Ladder Steps to the Slide Legs by inserting a long
screw through the holes of the Ladder Step and the Ladder Leg.
6.
opposite side of the Ladder Leg and under the Ladder Step. Tighten
the screw.
7.
Repeat steps 8 - 9 for the remaining Ladder Leg.
8.
Insert the Rear Stability Legs into the Ladder Legs.
9.
Fasten the Rear Stability Legs to the Ladder Legs by inserting a screw
through the Ladder Leg and Rear Stability Legs.
10.
opposite side. Tighten the screws.
11.
Align the hole in Side Support Leg Brace with the hole in the Ladder
Leg. Insert the screw and fasten with the washer and nut on the
oppostite side. Repeat for the other brace
12.
Fasten the other end of the Support Leg Brace with the Inner Leg
Support Tube.
Correct orientation for Slide Steps
5
Lo
M6*42mm*2pcs
M6*42mm*2pcs
M6*24mm*2pcs
ng Screw
Flat Washer
Hex Nut
11
11
10
To keep the Slide Legs from sinking into
the ground, dig a hole under the leg, and
Tip
