during installation, children can gravitate to unattended equipment, thereby increasing safety risks.
Do not attach swing chains, exercise rings, or similar moving components until the entire
construction is complete and safety surfacing is in place.
In addition, never leave the job site unattended without making sure that all open holes are covered
with a material such as plywood. Rope off all unfinished equipment to keep the children away until
the build is complete.
It is recommended that you have a Certified Playground Safety Inspector (CPSI) on site during
installation. Upon completion of the installation (including safety surfacing and all site amenities), the
playground should be audited by a Certified Playground Safety Inspector (CPSI) providing
documentation indicating the playground is installed correctly and meets the guidelines set forth by
the Consumer Product Safety Commission.
Tools required
With the tamper resistant hardware, the manufacturer provides a TORX-head tool
Tools normally required include the following:
Wheelbarrow (to mix concrete)
Power 3/8” drill (extension cord, if necessary)
String level, magnetic level, 4’ level
Standard tool kit- wrench set, Allen wrench set, tin snips, razor tool, etc.
Mallet
Shovels and rakes
Posthole digger / auger
Tape measure
WARNING LABELS
KidsTale provides warning labels that must be installed on vertical posts to comply with ASTM 1487,
which reads, “Warning: Installation over a hard surface such as concrete, asphalt or packed earth
may result in serious injury or death from falls.”
MANUFACTURER LABELS
KidsTale provides manufacturer labels in the installation kit. These labels must be installed to comply
with CPSIA Section 103A. A manufacturer label is required on each independent play unit.