10
ATTACH THE REAR WHEELS
Before you begin: Remove the axle nut and washer from the
end of the rear axle.
❶ Position the rear axle so the square shaped stabilizer end is
opposite of where the gear box is located. Figure 3.3
Tip!
If the gear box has slipped out of place during shipping,
you will need to re-insert the gear box.
❷ Slide the rear axle through the holes in the rear of the
vehicle body
.
❸ Position the flat side of the gear box pad facing towards the
gear box, and insert the gear box pad over the protrusions
on the gear box. Figure 3.4
❹ Slide the wheel all the way onto the axle until it meets the
large washer. Note: All the wheels are identical and can be
placed on any axle.
❺ Align the tabs on the hubcap with the slots in the wheel.
Press the hubcap into the wheel until in snaps into place.
❻ Slide the small washer onto the end of rear axle.
❼ Place the retainer nut onto the end of the rear axle and
tighten with the spanner.
❽
Align the tabs on the wheel cover with the slots in the
hubcap. Press the wheel cover into the hubcap until in snaps
into place.
❾ Repeat steps 4-8 for the opposite rear wheel.
4
1
Gear
box
8
5
6
7
3
3
Figure 3.4
Figure 3.3
Square shaped
stabilizer end
