29
Start-up
Type 8615500120-000 / 8615500130-000
13 sTarT-up
A detailed description of the start-up and operating
procedures can be found at our homepage in the
operating instructions for Type 8615500120-000 /
8615500130-000.
13.1 safety instructions
Warning!
risk of injury from improper operation!
Improper operation may result in injuries as well as damage to the
device and the area around it.
▶
Before start-up, ensure that the operating personnel are familiar
with and completely understand the contents of the operating
instructions.
▶
Observe the safety instructions and intended use.
▶
Only adequately trained personnel may start up the equipment/
the device.
13.2 starting-up Type 8615500120-000 /
8615500130-000
13.2.1 specifying the basic settings
The basic settings are made on the setting level.
To switch from the process to the setting level, press the
MENU
key for approx. 3 seconds.
For starting up you must specify the following basic settings:
• Setting the input signal (
INPUT
)
• Automatic adjustment of the positioner (
X.TUNE
)
Applies only to process valves that are not pre-assembled:
• Setting of the operating mode for the pneumatic actuator
(ACTUATOR)
The setting of the operating mode (control function A, B or I) in
the
ACTUATOR
menu, is described in the operating instructions
for Type 8615500120-000 / 8615500130-000.
In general, Type 8615500120-000 / 8615500130-000 is
supplied with a pre-assembled process valve. In this case
the operating mode of the actuator is already pre-set.
For this reason, the input of the control function (A, B or I) is
not required in case of a pre-assembled process valve.
English
Summary of Contents for 8615500120-000
Page 93: ......
Page 94: ...www kieselmann de...
