To fasten the child on the child restraint
• Place your child into the child seat and use the 5-point harness belt to fasten your child.
• Put the two buckle tongues (E&F) together and push into the harness buckle (G) with an audible CLICK! (Fig 6.a).Press down on the
strap adjuster as you pull the two shoulder straps with your other hand upwards until the harness is fully tightened, then let it go of
the adjuster button, the straps will be locked into place. Pull the shoulder straps towards you to loosen the harness. (Fig 6.b)
• Make sure the car seat belt is not tangled or twisted.
To adjust the position of the seat belt according to child’s weight
• There are three group belt slot of the child seat back, which can be used to adjust the location of the harness to adapt to
children’s weight (Fig7.a).
Use the bottom slot for children weight less than 6kgs.
Use the middle slot for children weight from 6kgs to 12kgs.
Use the upper slot for children weight from 12kgs to 18kgs.
• The child’s shoulders should always be below the slot for the harness when sitting on the child seat.
• When adjust the height of the harness straps, you need to release the harness strap from the connector(L) on the rear of the seat.
• Pull the harness strap through the correct slot and then hang to the connector.
• Make sure the car seat belt is not tangled or twisted.
ENGLISH
• Please ensure that all parts are placed in the right place, do not stuck in the seat belt or the car door.
• Any luggage or other objects liable to cause injuries in the event of a collision shall be properly secured.
• The child restraint must not be used without the cover.
• The seat cover should not be replaced with any other than the one recommended by the manufacturer.
• The child seat should not be used any more when it has been subject to violent stresses in an acident.
• Regular inspection, pay special attention to join point, suture and adjusting device.
• Child car seat back should be steady on car seat, if necessary can adjust the height of the seat headrest.
• The driver shall fasten the adult seat belt even if no child in the child restraint.
• Do not use any load bearing contact points other than those described in the instructions and marked in the child restraint.
3. Installation and Instructions
Group 0:
Group 1:
