3-10
KFM2151
Operation
Setting the channel assignments
Fig.3-7
Example of the display sho
w
n
w
hen assigning channels
1.
Check that the KFM2151 is in monitor mode.
If the CHANNEL display or VOLT/TERM display is blinking, press the MON key.
2.
Press the IMP/
V
OLT key.
Select impedance (IMP) or voltage (VOLT).
The IMP LED and VOLT LED illuminate alternately each time you press the IMP/
VOLT key.
3.
Press the
and
keys or SHIFT+
and
keys to select the
channel n
u
m
b
er.
4.
Press SHIFT+TERM to make TERM-
b
link.
The TERM LED illuminates in green. The left two digits of the VOLT/TERM display
correspond to TERM-, and the right two digits correspond to TERM+.
TERM+ and TERM- blinks alternately each time you press SHIFT+TERM.
5.
Press the
and
keys or SHIFT+
and
keys to select the
terminal n
u
m
b
er (1 to 32).
A buzzer sounds if the selectable range is exceeded.
6.
Press SHIFT+TERM to make TERM+
b
link, and set it in the same
manner.
7.
Press SHIFT+TERM to confirm.
TERM- blinks again.
8.
Press the MO
N
key.
The KFM2151 enters monitor mode. To set other channels, repeat steps step 2 to step
7 .
IMP
IMP
VOLT
VOLT
V
V
CH
CH
OVP
OVP
UVP
UVP
RANGE
RANGE
TERM
TERM
VOLT TERM
CHANNEL
Channel number
TERM+
TERM-
Illuminated
Summary of Contents for KFM2151
