KFM2151
2-7
Installation and Preparation
When using multiple KFM2151s (channel expansion)
Up to five KFM2151s (one master and four slave units) can be connected.
An example in which two KFM2151s are connected to the KFM2150 is given
below. If you are connecting three or more KFM2151s, connect them in the same
manner as the connection between the KFM2151 master unit and the slave unit
shown in Fig.2-4.
Fig.2-4
Connection of t
w
o KFM2151s to the KFM2150
The optional channel expansion cable is not included in the package. If you are
connecting multiple KFM2151s, contact your Kikusui agent.
Fig.2-5
Channel expansion ca
b
le (option)
1.
Check that the PO
W
ER s
w
itch is t
u
rned off on the KFM2151 and
KFM2150.
2.
Connect the KFM2150 and the KFM2151 master
u
nit.
3.
Use the channel expansion ca
b
le (option) to connect the SCA
NN
ER
OUT terminal of the master
u
nit to the SCA
NN
ER I
N
terminal of the
sla
v
e
u
nit.
4.
Connect the I
N
terminal of the master
u
nit to the OUT terminal of the
sla
v
e
u
nit
u
sing the scre
w
less terminal connector (
b
ipolar).
KFM2151 slave unit
KFM2151 master unit
KFM2150
KFM2150 connection cable
Channel expansion cable
Wire (twist)
Wire (twist)
[91-
8
0-9901]
See
See
Summary of Contents for KFM2151
