28
PCR-M
Chapter 2 Installation and Preparation
2.7
Turning the Power On
Turning the POWER switch on
Turn the power on without the load connected.
1.
Check that the POWER switch is turned off ( ).
2.
Check that nothing is connected to the OUTPUT terminal block on the
rear panel and the OUTPUT outlet on the front panel.
3.
Check that the power cord is correctly connected.
4.
Turn the POWER switch on.
Push the ( ) side of the POWER switch to turn the PCR-M on.
If an odd sound, odd odor, fire, or smoke occurs around or in the PCR-M, remove the
power plug from the outlet or turn off the switchboard.
5.
Check the firmware version on the front panel display.
The firmware version as shown in Fig. 2-7 is displayed for few seconds, and
a self-test is carried out. If no error is detected, the measured value display appears.
Fig.2-7
Checking the firmware version
(Example: Ver.1.23, PCR500M)
The measured value display appears after displaying the firmware version.
If the POWER switch is turned on for the first time after purchasing the PCR-M, the
PCR-M starts up using factory default settings. For all other cases, the PCR-M starts
up using the settings that existed when the POWER switch was turned off the last
time.
Fig.2-8
Measured value display
If the ALARM LED illuminates or an error number is displayed, see section
3.11, “Protection Functions and Alarm Errors.”
See
V
Hz
PEAK
Hz
135V
270V
RANGE
AC
DC
W
A
AVG
RMS
AUTO
MEMORY
REMOTE
ALARM
KEY LOCK
EXT
A
B
C
OVER LOAD
Upper display: Model (PCR500M)
Lower display: Firmware version (Ver. 1.23)
V
Hz
PEAK
Hz
135V
270V
RANGE
AC
DC
W
A
AVG
RMS
AUTO
MEMORY
REMOTE
ALARM
KEY LOCK
EXT
A
B
C
OVER LOAD
Summary of Contents for PCR 2000M
Page 34: ...34 PCR M Chapter 2 Installation and Preparation ...
Page 79: ...Appendix ...
Page 91: ...PCR M 91 ...