54
PCR-M
Chapter 3 Operation
OUTPUT on phase
Set the OUTPUT on phase for AC mode.
When using the OUTPUT on phase control, also set the phase angle.
• OUTPUT on phase
ON (
): OUTPUT on phase control enabled
OFF (
): FREE operation (no phase control)
• Phase angle
0 deg to 359 deg: Range for phase angle setting
Averaging period
You can select the averaging period of the measured values (excluding the peak
current).
• Measured value averaging
ON (
): Displays the moving average over approximately 3 seconds
OFF (
): Updates and displays approximately every 0.3 s
Hold time of peak current
You can change the hold time of the peak current.
• Peak hold time
SHORT (
): Updates approximately every 0.3 s
LONG (
): Holds the peak value for approximately 5 seconds If a
greater peak value is measured while holding, the new peak
value is held for approximately 5 seconds from that point.
Communication interface
The functions of the PCR-M can be expanded by installing an interface board to the
option slot. However, the GPIB, RS232C, and USB interfaces cannot be used
simultaneously.
• Communication interface type
To activate the settings, the POWER switch must be turned off when at least 5
seconds elapses after changing the settings and then turned back on.
232 (
):
RS232C (standard equipped)
488 (
): GPIB (selectable only when the optional interface board is
installed)
USB (
): USB (selectable only when the optional interface board is
installed)
Summary of Contents for PCR 2000M
Page 34: ...34 PCR M Chapter 2 Installation and Preparation ...
Page 79: ...Appendix ...
Page 91: ...PCR M 91 ...