PFX2512_CE
39
Setting the Electronic Load
2
In
st
al
la
ti
on
a
n
d P
re
p
ar
a
ti
o
n
Setting the external analog control
Set the item concerning the external analog control to the following condition by using the
CONFIG setting.
For detailed setting procedure, refer to the chapter "Basic operation" of the operation manual of
PWR series or PAS series.
Setting the Electronic Load
Set the protection function to protect the DUT (battery) and the connected equipments.
When the Electronic load is connected in parallel operation, assign the master unit and the slave
unit.
Set the external analog control to control the PFX2512.
PLZ-4W
series
It is recommended to set the lock function when all the settings are completed. It prevents from
being changed of setting by the operational error.
1
Set the PLZ-4W series, to the factory default settings. Turn on the POWER
switch while keep pushing the ENTER key.
The contents of stored memory is cleared.
2
Set the protection functions.
If the factory setting were applicable, you don't need to set the protection functions.
3
When the PLZ-4W series is connected in parallel (maximum discharge power :
2 kW), assign the master unit and the slave unit.
4
Set the external analog control.
5
Set the slew rate.
6
When the LOCK (SHIFT + LOCAL) key of the PLZ-4W series is pressed, the key
icon will be displayed and the panel operation becomes disabled.
Press the LOCK (SHIFT + LOCAL) key again to release the panel lock. Keep pressing
down the key for few seconds until the beep sound comes out. The key icon clears,
and the lock is released.
Model
CV control source settings
CC control source settings
External control logic setting
of the output on/off
PWR series
External voltage control
(C-1:1)
External voltage control
(C-2:1)
Turn the output on with a
low signal (C-6:1)
PAS series
External voltage control
(DIGIT A:1)
External voltage control
(DIGIT B:1)
Turn the output on with a
low signal (DIGIT F:1)
Ope
• Even when the panel operation is locked, the key operation for the output on/off is enable to
function. It may cause the damage of the test data if the operation of output on/off is conducted
during the charge and discharge testing.
• Adjustment is not required for connecting the equipments.
Summary of Contents for PFX2515
