Interface Setup
KIKUSUI Electronics Corp.
PWR-01 Interface Manual
■
USB function
Complies with USB Specification 2.0
Complies with USBTMC Specification 1.0 and USBTMC-USB488 Specification 1.0
Data rate: 480 Mbps maximum (High speed)
VID (Vender ID)
0x0B3E
PID (Product ID)
PWR-01 400W model: 0x1049
PWR-01 800W model: 0x104A
PWR-01 1200W model: 0x104B
LAN
To use the LAN interface to control the PWR-01, middleware that supports the SC-
PI-Telnet/ VXI-11/ HiSLIP/ SCPI-RAW protocol must be installed on the controller.
The middleware is installed automatically by the VISA library.
There is a Web browser interface to the PWR-01 embedded in the LAN interface
board. You can configure the LAN interface settings from your PC's Web browser.
For information on topics such as connecting to your corporate LAN, your IP ad-
dress, your host name, and security, contact your network administrator.
If you are using a host name (a Bonjour host name), you have to install Apple Bon-
jour.
■
LAN connection
Use a standard LAN cable (category 5 and straight) to connect the PWR-01 to a
network hub or router. Use a crossover cable when making a direct connection.
The LAN port of this product comes with a cover. Remove the cover to use the port.
Store the cover in a safe place so that you can use it to cover the LAN port when
the port is no longer in use. For safety reasons, when not using the LAN port, be
sure to attach to cover. For safety reasons, when not using the sensing terminals,
be sure to attach to terminal cover.
Port cover
[P1-000-131]
The PWR-01 RS232C port is the same shape as a LAN port. Check the port name
marked on the rear panel to identify the appropriate one to use.
WARNING
If a network problem occurs, an unexpected dangerous voltage may oc-
cur that may cause electric shock, fire, physical damage to the DUT, and
so on. If you are going to remotely control the PWR-01 from a distance,
install a Web camera or take other measures to monitor the status.
