TOS9213S/ TOS9213AS
5-55
Setting the repeat test
To make settings necessary to repeat a test, use the SHIFT + F2 keys, regardless of
the location of the cursor.
Each time the SHIFT + F2 keys are pressed, END and RET alternate.
END: The program ends, the tester returns to the first step and enters the
READY status and.
RET: The program returns to the first step and starts a new test.
5.11.2 Executing a program
• Releasing the START switch when START MOMENTARY is on is equivalent to
pressing the STOP switch. As a result, in a programmed automatic test, the test is
unable to proceed to the next step if the step interval is set to HOLD.
• If the test executes a step with the timer function set to OFF, it is unable to proceed
to the next step.
To run a program, display the program screen (AUTO).
1.
Press the AUTO key to display the program screen (AUTO).
2.
Using the rotary kno
b
, specify the n
u
m
b
er of the program to
b
e recalled.
The name of the selected program is displayed to the right of the program
number.
To check the memory contents, press the SHIFT + F1 keys. The cursor will
move to the step number. Using the rotary knob, select a step number. The test
conditions for the selected step are displayed.
3.
To r
u
n the program, press the START s
w
itch.
During the test, “TEST” is displayed and the TEST LED lights up on the indicator.
The step being run is displayed in reverse image.
5.11.3 Suspending the program
To suspend the test while running a program, press the STOP switch.
To start the program from the beginning, press the START switch.
NOTE
AUTO
AUTO
TEST
PRG
05 : KIKUSUI
TOTAL: 2
01 DCW00-0.2s
02 IR 00-0.2s
03
▼
NAME : --UNTITLED--
CH :
1.00
kV
12
A
3.0
s
NORM
INTVL : 0.2 s
