TOS9213S/ TOS9213AS
2-7
2.5
Connecting the AC Power Cord
• This prod
u
ct is an IEC Safety Class I eq
u
ipment (eq
u
ipment
w
ith a protec-
ti
v
e cond
u
ctor terminal). To pre
v
ent electric shock,
b
e s
u
re to gro
u
nd
(earth) the
u
nit.
• This prod
u
ct is gro
u
nded thro
u
gh the gro
u
nd
w
ire of the po
w
er cord. Be
s
u
re to connect the po
w
er pl
u
g to an o
u
tlet
w
ith an appropriate earth
gro
u
nd.
• Use the supplied power cord to connect to the AC line.
• If the supplied power cord cannot be used due to the rated voltage or the plug
shape, have the cord replaced with an appropriate power cord of length 3 m or less
by a qualified engineer. If obtaining a power cord is difficult, consult your Kikusui
agent or distributor.
• In an emergency, the power cord with a plug may be used to disconnect the prod-
uct from the AC line in an emergency. Connect the plug to an easily accessible
power outlet so that the plug can be removed from the outlet at any time. Be sure
to allow enough space around the power outlet.
• Do not use the supplied power cord on other instruments.
This product is an equipment of IEC Overvoltage Category II (energy-consuming
equipment supplied from the fixed installation).
1.
T
u
rn the PO
W
ER s
w
itch off.
2.
Check that the AC po
w
er line complies
w
ith the inp
u
t rating of the tester.
3.
Connect the po
w
er cord to the AC LI
N
E connector on the rear panel,
connect the po
w
er cord pl
u
g to an o
u
tlet
w
ith proper gro
u
nding.
Fig.2-4
Pl
u
g connection
WARNING
NOTE
Grounded three-contact
electrical outlet
