Page 1 of 9
Killion Industries, Inc. • 1380 Poinsettia Ave., Vista, CA 92081
Phone (760) 727-5102 • Toll Free (800) 421-5352 • Fax (760) 727-1622
www.killionindustries.com • Sales@killionindustries.com • Parts.Service@killionindustries.com
Shipment Examination
If the packaging is externally damaged, do not accept the shipment unless the damage is listed on the Bill of
Lading and the crate/packaging is opened in the presence of the carrier’s agent.
If there is no visible external damage; but the contents are damaged, or goods are missing, have the carrier’s
agent inspect the shipment immediately for concealed damage.
On all shipments, consignee will be responsible for filing a claim with the carrier. If replacement parts are
required, send order to:
KILLION INDUSTRIES, INC.
1380 Poinsettia Ave.
Vista, CA 92081
Toll Free (800) 421-5352 ext. 120
Fax (760) 727-1622
parts.service@killionindustries.com
Location
Killion refrigerators are Type 1 Open Display Refrigerators and designed to operate in air-conditioned stores
where temperature and relative humidity are maintained at or below 75°F dry bulb temperature and 55%
relative humidity. Avoid locations where the refrigerator is exposed to heat sources such as the sun’s rays or hot
tables as these external heat sources can affect the refrigerator’s efficiency.
Do not enclose refrigerated display case with walls. There should be ample space on each side of the
condensing unit to facilitate free airflow. Closing off the sides by any means will cause the refrigerator undue
strain, and could damage the compressor.
Air drafts will affect the refrigerator’s temperature holding capability. Be certain there is no air-conditioning or
heating vents discharging air into the display case area. Overhead fans, swamp coolers, or anything that
creates a draft will disrupt the air curtain and adversely affect the refrigerator. An open door will sometimes
create an air movement that will sweep the refrigerated air out of the merchandising area.
Do not locate the refrigerator under a low ceiling. There should be at least four feet (48") of free space above
the merchandiser at all times. A low ceiling can lead to reduced temperature holding capacity and expose
the unit to undue strain. Additionally, nothing can be stacked on top of the unit, as this will also interfere with
proper ventilation.
Do not locate the refrigerator directly against a wall. There should be a minimum of six inches between the
rear of the refrigerator and any wall behind the unit.
PRE-INSTALLATION
Read the entire INSTALLATION SECTION before
placing the unit in its final location.
ATTENTION
Lisez la SECTION d'INSTALLATION entière avant de placer l'unité
dans son endroit final
.
ATTENTION
