Tables Assembly Instructions
Aspire
Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call Kimball Office Customer Care.
Part No. 1741509 Revision A-05
Page 4 of 5
Installation (continued)
10. Remove old locating pins in center rail and replace with
new pins from package (two required). (Figure K).
Note: If opposite gear has already been replaced during this
work session, the locating pins are still good.
11. Apply small amount of Lubriplate, Vaseline or other similar
lubricant to center portion of support tube. Slide new
gear/ring assembly onto support tube and fully seat
assembly against center rail. Make sure assembly fully
engages locating pins. (Figure L).
Note: Re-check gear to make sure it is a match for the gear
on the opposite side of the rail.
12. Attach gear/ring assembly to center rail with new
male/female fastener. Fastener inserts into both sides of
center rail. Tighten fastener firmly, but do not over-tighten.
(Figure M).
13. Make sure all cabling and support bars are in their
approximate correct positions. Carefully match up holes
and recesses and re-install “heart” mechanism onto bars and
support tubes. Use rubber mallet to fully seat “heart” into
position. Re-install the two set screws in the bottom of the
“heart”. (Figure N).
Figure L
Figure N
Figure K
Figure M
Lubricate center
area of support
tube
Insert new
gear assembly
Attach Gear with
new Male/Female
Fastener
Make sure all cabling
is properly aligned
Re-install set screws
Re-install
“Heart”
Replace old locating
pins with new ones
